Track Brake Assembly
The Track Brake can be assembled in a few
minutes.
1. Drill a 3/16” hole in the center and 1/2” from
the end of your track. This hole will be used to attach
the brake to your track. |
2. Assemble the brake as shown in the diagram using the included
screws and nuts. It is important that the screws be inserted
in the correct direction. The screw at the base should
be pointed up and the tapered hole in the base should be down.
The screw at the top of the ramp should be pointed down. Tighten
both screws then put the brake on a flat surface. If the base
is not flat on the surface, bend the leg slightly so that the
base is flat. |
3. Next, attach the brake to the track by sliding the low end
of the brake under the track until the two holes line up. Insert
a screw from under the brake and through the hole on the track,
screw on the nut and tighten. |
| 3. Do not paint or polish the top side of the brake
or you will reduce the brake's ability to stop your cars. |
Return to Practice Track Page |
view
shopping cart 
product
catalog
